Legacy Brand Coin Ring MEGA Punch and Spacer Set:
Instructional Video for the punch:
This set includes a durable punch body made from 4140 steel and 2″ inches inside diameter.
There are also five different punches and accompanying dies made from O-1 tool steel and heat treated for maximum durability.
The five punch sizes make holes that are 3/8″ inch, 7/16″ inch, 1/2″ inch, 9/16″ inch, and 5/8″ inch.
Included 61 piece ABS plastic 3D printed spacer set. Spacer inner diameters range from 15 mm to 45 mm in 0.5 mm increments. For coins that fall in between spacer sizes, use a small piece of paper towel to “shim” the coin into the spacer for a perfect center hole punch.
Use a 6 ton hydraulic press or a 2.5 pound brass hammer with this set.
This punch has a maximum inner diameter of 2″ inches (50.8 mm) and fit’s just about every coin out there. With the included spacer set, you can center punch five different hole sizes in hundreds of different coins, both foreign and US. The fourth picture in this listing, shows the variety of coins that can be center punched with this punch and spacer set. The coins shown are a US penny, US dime, US Nickel, US Quarter, US Half Dollar, US Silver Eagle, One ounce Copper Round, and a Challenge Coin. (Thank You to Tony Lloret for the beautiful challenge coin).
This is a quality coin ring punch set, made in the USA by American craftsmen, and made to last.
No coins are included with this listing.
These printed spacer sets may have the occasional rough edge or micro filament of plastic residual left over from the 3D printing process. If you find any irregular edges on your spacers, a light touch of sanding with 500 grit sandpaper (included) will clean up any minor issues.